NQ710D双组份聚氨酯导电地板胶

主要使用建筑物内各种导电,抗静电弹性地板(PVC,橡胶)卷材,片材地板与基础物粘接。

It can be used in the buildings for electric conductivity,anti-electrostatic bonding for plastic or Rubber sheet and tile to substrate special for heavy-duty floor.

施工方法 Application Instruction

1、使用前，请打开大桶(12.5kg),然后将小桶(2.5kg)中的组份彻底倒入大桶并用合适的电动搅拌器(螺旋式、桨式或笼式搅拌器)充分搅拌本品。随后将充分搅拌的混合物倒入另一只干净的容器，并再次稍作搅拌。确保充分搅拌，尤其应注意桶壁和桶底部位。

Before use, please open the large bucket (12.5kg), then pour the components in the small bucket (2.5kg) thoroughlyinto the bucket and fully mix the product with a suitable electric mixer (screw type, paddle type or cage type mixer).Then pour the fully stired mixture into another clear container and stir slightly again. Ensure adequate mixing, especially on the wall and bottom of the drum.

2、用合适的刮板将本品均匀涂布至基层表面。随后立即铺设地板，并对铺设区域全面擦压。2-3小时再次擦压地板。掌握合适的用量，确保粘大合剂充分转移至地板背面。在重载负荷区域、室外和潮湿区域铺设锥粒背衬地板时，在铺设地板前请用本品将锥粒背衬填平。请迅速施工，注意适用期。

Apply the product evenly to the base surface with a suitable scraper. The floor shall be laid immediately and the laying area shall be fully rubbed and pressed. Wipe and press the floor again in 2-3 hours. Grasp the appropriate amount to ensure that the adhesive is fully transferred to the back of the floor, Whenlaying the cone backing foor in heavy load area, outdoor and wet area, please use this product to fill the floor before laying the floor. Please work quickly and pay attention to the applicable period.

理论涂布量   Theoretical application rate

4.45-5㎡/kg

保质期   Quality Grarantee Period

在0-40℃库房内储存，保质期为12个月。

12 months if stored in 0-40℃.

注意事项   Notes

本品在运输，储存和施工过程中防止严寒及阳光暴晒，施工温度不低于5℃。

The product should be protected against frost and direct light during transportation, storage and application.Application temperature should not be lower than 5℃.

产品资料下载‍   File Download